TLE5010
From 229ahb
Revision as of 06:24, 20 February 2020 by WikiSysop (talk | contribs) (Created page with " '''Axis rotation detection from a single sensor, single magnet''' an example of usage of the magnetic angular sensor on DIY pedals 300px Note: t...")
Axis rotation detection from a single sensor, single magnet
an example of usage of the magnetic angular sensor on DIY pedals
Note: the diametrical magnet is located at the centre axis on the head of the pivoting bolt (not immediately obvious from angle of this image)
Solder the wiring connector supplied with the TLE5010 sensor to the Pro Micro (MMJoy2) HID USB board as illustrated:
| Wiring Pinouts | |||
|---|---|---|---|
| Func | Wire Colour | Pro Micro Pin | 
|
| GEN | White | 10 (MMjoy B6) | |
| SCK | Blue | 15 (MMjoy B1) | |
| MISO | Green | 14 (MMjoy B3 | |
| NEG | Yellow | GND | |
| CS | Black | A2 (MMjoy F5 | |
| POS | Red | VCC | |
Note: Be certain you have diametrical magnets
They stack like this.
NOT like this
All the technical information you could ever need regarding the TLE5010 GMR-Based Angular Sensor:
https://4donline.ihs.com/images/VipMasterIC/IC/INFN/INFNS12044/INFNS12044-1.pdf
