TASK 2000

From 229ahb
Revision as of 05:53, 20 February 2020 by WikiSysop (talk | contribs) (Created page with " '''Exract: TC 1-211 AIRCREW TRAINING MANUAL UTILITY HELICOPTER, UH-1H/V SERIES''' '''TASK 2000''' '''Perform FM radio homing''' '''CONDITIONS:''' In a UH-1 helicopter...")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
Exract: TC 1-211 AIRCREW TRAINING MANUAL UTILITY HELICOPTER, UH-1H/V SERIES

TASK 2000
Perform FM radio homing

CONDITIONS: In a UH-1 helicopter and given a radio frequency.

STANDARDS: Appropriate common standards plus these additions/modifications:
1. Tune and identify the station.
2. Turn to the homing station.
3. Use the correct homing procedures.
4. Identify station passage.

DESCRIPTION:
1. Crew actions.
 a. The pilot on the controls (P*) will remain focused primarily outside the aircraft
 throughout the maneuver for aircraft control and obstacle avoidance.
 
 b. The pilot not on the controls (P) will tune and identify the station, assist in setting up the
 course deviation indicator (CDI), and provide turning guidance. The P and nonrated
 crewmember (NCM) will remain focused primarily outside the aircraft and clear the aircraft.
 They will provide adequate warning of traffic or obstacles. They will announce when their
 attention is focused inside the aircraft and again when attention is reestablished outside.

2. Procedures.
 a. Establish radio contact with the homing station and specify definite transmission and
 pause periods. Set the frequency modulation (FM) radio per the appropriate aircraft
 operator’s manual. (Set the mode selector switch on the FM control panel to HOME.)
 
 b. The P* will fly the aircraft to the station by heading in a direction that will cause the
 course deviation pointer in the radio magnetic indicator (RMI) to center. The P* will solve
 ambiguity by changing the heading when the pointer centers and by checking that the pointer
 drifts in the opposite direction. While homing to the station, the P* will change heading
 slightly (10 to 15 degrees) during the transmissions and observe that the vertical pointer
 continues to deflect in the opposite direction. If the pointer shows a turn in the same
 direction, it indicates that the aircraft has passed the station. The P* will continue the turn and
 attempt to identify the station visually or verify the position.
 
 c. The P and NCM will assist in clearing the aircraft and provide adequate warning of
 traffic or obstacles. They will announce when their attention is focused inside the aircraft.

TRAINING AND EVALUATION REQUIREMENTS:
1. Training will be conducted in the aircraft.
2. Evaluation will be conducted in the aircraft.

REFERENCES: Appropriate common references.