WikiSysop: Created page with " '''Axis rotation detection from a single sensor, single magnet''' an example of usage of the magnetic angular sensor on DIY pedals 300px Note: t..."

2020-02-20T06:24:17Z

Created page with " '''Axis rotation detection from a single sensor, single magnet''' an example of usage of the magnetic angular sensor on DIY pedals 300px Note: t..."

New page

'''Axis rotation detection from a single sensor, single magnet'''

an example of usage of the magnetic angular sensor on DIY pedals

[[File:TLE5010_mnt.png|300px]]

Note: the ''diametrical'' magnet is located at the centre axis on the head of the pivoting bolt (not immediately obvious from angle of this image)

Solder the wiring connector supplied with the TLE5010 sensor to the Pro Micro (MMJoy2) HID USB board as illustrated:

{| class="wikitable" cellpadding="10"
! colspan="4"| Wiring Pinouts
|-
|'''Func'''
|'''Wire Colour'''
|'''Pro Micro Pin'''
|rowspan="7"|[[File:TLE5010.png|600px]]

|-
|GEN
|White
|10 (MMjoy B6)
|-
|SCK
|Blue
|15 (MMjoy B1)
|-
|MISO
|Green
|14 (MMjoy B3
|-
|NEG
|Yellow
|GND
|-
|CS
|Black
|A2 (MMjoy F5
|-
|POS
|Red
|VCC
|}

Note: Be certain you have diametrical magnets

They stack like this.

[[File:diametrical_magnets.jpg]]

'''NOT''' like this

[[File:magnets.jpg]]

All the technical information you could ever need regarding the TLE5010 GMR-Based Angular Sensor:

https://4donline.ihs.com/images/VipMasterIC/IC/INFN/INFNS12044/INFNS12044-1.pdf

TLE5010 - Revision history

WikiSysop: Created page with " '''Axis rotation detection from a single sensor, single magnet''' an example of usage of the magnetic angular sensor on DIY pedals 300px Note: t..."